Abstract
Accurate estimation of aerodynamic state variables such as freestream velocity and angle of attack (AoA) is important for aerodynamic load prediction, flight control, and model validation. This work presents a non-intrusive method for estimating vehicle velocity and AoA from structural vibration measurements rather than direct flow instrumentation such as pitot tubes. A dense array of piezoelectric sensors mounted on the interior skin of an aeroshell capture vibrations induced by turbulent boundary layer pressure fluctuations, and a convolutional neural network (CNN) is trained to invert these structural responses to recover velocity and AoA. Proof-of-concept is demonstrated through controlled experiments in Sandia's hypersonic wind tunnel spanning zero and nonzero AoA configurations, Mach~5 and Mach~8 conditions, and both constant and continuously varying tunnel operations. The CNN is trained and evaluated using data from 16 wind tunnel runs, with a temporally centered held-out interval within each run used to form training, validation, and test datasets and assess intra-run temporal generalization. Raw CNN predictions exhibit increased variance during continuously varying conditions; a short-window moving-median post-processing step suppresses this variance and improves robustness. After post-processing, the method achieves a mean velocity error relative to the low-pass filtered reference velocity below 2.27~m/s (0.21\%) and a mean AoA error of $0.44^{\circ} (8.25\%)$ on held-out test data from the same experimental campaign, demonstrating feasibility of vibration-based velocity and AoA estimation in a controlled laboratory environment.